Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
1. Position a wood block squarely over the end of the outer joint threaded shaft.
2. Use a hammer to drive the outer joint onto the bar.
3. Continue to drive the outer joint until you feel the outer joint seat fully onto the wheel drive shaft bar.
4. Inspect to be sure that the axle shaft and the inner race stepped surfaces are fully seated to each other.
9. Position the small end of the seal (8) over the mating groove in the wheel drive shaft bar.
10. Compress the small clamp using the J 43218 or equivalent, until dimension (A) is 0.5-1.6 mm (0.02-0.06 in).
11. Vent the joint to relieve excess trapped air.
12. Compress the large clamp using the J 43218 or equivalent, until dimension (A) is 0.5-1.6 mm (0.02-0.06 in).
13. Install the wheel drive shaft.
