Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
Constant Velocity Joint: Service and Repair
Wheel Drive Shaft Outer Joint and Seal Replacement
Wheel Drive Shaft Outer Joint and Seal Replacement
Tools Required
J 43218 Clamp Pliers - Narrow Jaw
Removal Procedure
1. Remove the wheel drive shaft.
2. Wrap a shop towel around the axle shaft.
3. Place the wheel drive shaft horizontally in the bench vise.
4. Remove the large seal clamp (2) and the small seal clamp (1). Use a side cutter or other suitable tool and discard the clamp.
5. Separate the seal (8) from the joint (5) outer race at the large end.
6. Position the seal behind the joint face.
