Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
2. Install the seal onto the wheel drive shaft bar.
3. Install the retaining ring onto the wheel drive shaft bar.
4. Insert the grease from the service kit into the outer joint.
5. Position the outer joint horizontally.
6. Engage the inner race splines onto the axle shaft splines.
7. Compress the axle shaft retaining ring.
1. Press one end of the retaining ring, using a flat-bladed screwdriver or equivalent tool, into the wheel drive shaft bar groove while firmly
pressing the outer joint onto the axle shaft.
2. Continue to work around the retaining ring until it is compressed.
8. Install the outer joint to the wheel drive shaft bar.
