Savana 3500 V8-6.6L DSL Turbo VIN 6 (2007)
1. Clean all corrosion or contaminates from the steering knuckle bore and the hub and bearing.
2. Lubricate the steering knuckle bore with wheel bearing grease or the equivalent.
3. Install the wheel hub and bearing and splash shield to the steering knuckle.
Notice: Refer to Fastener Notice .
4. Install the wheel hub and bearing mounting bolts.
Tighten the bolts to 180 N.m (133 lb ft).
5. Install the wheel speed sensor to the wheel hub and bearing.
6. Install the wheel speed sensor retaining bolt.
Tighten the bolt to 18 N.m (13 lb ft).
7. Install the rotor.
8. Install the tire and wheel.
9. Lower the vehicle.
