Savana 4500 V8-6.6L DSL Turbo (2009)
Speaker: Service and Repair
Radio Rear Speaker Replacement
Radio Rear Speaker Replacement
Removal Procedure
1. Remove the rear header trim panel, if equipped.
2. Remove the nuts retaining the rear header speaker housing to the vehicle.
3. Remove the rear header speaker housing from the vehicle.
4. Disconnect the electrical connector from the speaker.
5. Remove the screws retaining the rear header speaker to the rear header speaker housing.
6. Remove the rear header speaker from the rear header speaker housing.
Installation Procedure
1. Install the rear header speaker to the rear header speaker housing.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the screws in order to retain the rear header speaker to the rear header speaker housing and tighten to 2 Nm (18 lb in).
3. Connect the electrical connector to the speaker.
4. Install the rear header speaker housing to the vehicle.
5. Install the nuts in order to retain the rear header speaker housing to the vehicle and tighten to 6 Nm (53 lb in).
