Savana 4500 V8-6.6L DSL Turbo (2009)
1. Partially install the front door trim plate (1) to the front door trim panel.
2. Connect the electrical connectors to the switches, if equipped.
3. Align the retainers on the front door trim plate (1) to the slots in the front door trim panel
4. Push towards the door panel to engage the front door trim plate (1) retainers.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
5. Install the screws (2) and tighten to 1.9 Nm (17 lb in).
6. Install the inside door handle bezel. Refer to Front Side Door Inside Handle Bezel Replacement (See: ).
7. Install the window regulator handle, if equipped. Refer to Door Window Regulator Handle Replacement (See: Front Door Window
Regulator/Service and Repair).
Front Side Door Front Garnish Molding Replacement
Front Side Door Front Garnish Molding Replacement
Removal Procedure
1. Grasp the front door front garnish molding.
Gently pull at the top of the molding in order to disengage the retaining clips.
2. Lift the front door front garnish molding up to disengage the tab on the garnish molding from the slot on the door trim panel.
3. Inspect the front door front garnish molding for broken or missing retaining clips. Replace any clips, if needed.
Installation Procedure
