Savana 4500 V8-6.6L DSL Turbo (2009)
Front Side Door Emblem/Nameplate Replacement (Savana Pro)
Special Tools
J 25070 Heat Gun
Removal Procedure
Note: Use the tape for protection and alignment marks for alignment of the new emblem.
1. Apply tape to the area around the door emblem.
2. Heat the emblem/nameplate, using a heat gun J 25070 152 mm (6.0 in) from the surface.
3. Apply the heat using a circular motion for about 30 seconds.
Caution: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.
4. Remove the emblem/nameplate from the door surface using a plastic, flat-bladed tool.
5. Remove all adhesive from the door panel surface and the back of the emblem/nameplate using 3M(TM) Scotch Brite Molding Adhesive Remover
Disk 3M(TM) P/N 07501 or equivalent.
6. Clean the door surface using varnish makers and painters (VMP) naptha.
Installation Procedure
1. If the location of the emblem/nameplate has not been marked, apply tape.
2. Warm the door surface with a heat gun J 25070 152 mm (6.0 in) from the surface to a minimum of 21°C (70°F).
Note: Do not touch the adhesive backing of the emblem/nameplate.
3. Remove the backing from the front end of the emblem/nameplate.
4. Press the emblem/nameplate to the door panel surface while continuing to remove the backing.
5. Hand roll the emblem/nameplate to the door panel to ensure proper adhesion.
6. Inspect the emblem/nameplate for bonding.
7. Remove the tape from the area around the door emblem.
Radiator Grille Emblem/Nameplate Replacement
Radiator Grille Emblem/Nameplate Replacement
