Savana 4500 V8-6.6L DSL Turbo (2009)
1. Open cover and remove screw, if equipped with roof rail inflatable restraints.
2. Pull out on the center pillar garnish (1 ,2) molding to disengage the clips.
3. Remove the center pillar garnish molding.
Installation Procedure
1. Align the body side upper (1 ,2) garnish molding clips to the holes in the body.
2. Push in on the body side upper (1 ,2) garnish molding to engage the clips.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install screw and close cover, if equipped with roof rail inflatable restraints and tighten to 2 Nm(18 lb in).
Body Side Rear Trim Panel Replacement
Body Side Rear Trim Panel Replacement
