Savana 4500 V8-6.6L DSL Turbo (2009)
Note: Note the position and the length of the bolts removed. This will assist with reassembly.
4. Remove the right and left bolts that retain the seat back frame to the seat back hinges.
5. Remove the seat back frame.
Installation Procedure
1. Install the seat back frame.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the bolts that retain the seat back frame to the seat back hinges in the locations noted during disassembly and tighten to 30 Nm (22 lb ft).
3. Install the 2 bolts at the outer seat riser from the seat back frame and tighten to 30 Nm (22 lb ft).
4. Install the seat back cover and pad. Refer to Rear Seat Cushion Cover and Pad Replacement (See: Seat Cushion/Service and Repair/Rear Seat
