Savana 4500 V8-6.6L DSL Turbo (2009)
9. Position the brake caliper and bracket assembly (1) to the rear axle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
10. Install the brake caliper bracket bolts (1) and tighten to 300Nm (221 lb ft).
11. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
12. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
13. Slowly release the brake pedal.
14. Wait 15 seconds, then repeat steps 14-15 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
15. Fill the brake master cylinder. Refer to Master Cylinder Reservoir Filling (See: Hydraulic System/Brake Master Cylinder/Service and
Repair/Procedures/Master Cylinder Reservoir Filling).
16. Burnish the brake pads and rotors. Refer to Brake Pad and Rotor Burnishing (See: Brake Pad and Rotor Burnishing).
