Savana 4500 V8-6.6L DSL Turbo (2009)
1. Install the anti-rattle clips to the brake caliper bracket.
2. Install the brake caliper. Refer to Rear Brake Caliper Replacement (With Single Rear Wheel) (See: Brake Caliper/Service and Repair/Removal
and Replacement/Rear Brake Caliper Replacement (With Single Rear Wheel))Rear Brake Caliper Replacement (Dual Rear Wheel) (See: Brake
Caliper/Service and Repair/Removal and Replacement/Rear Brake Caliper Replacement (Dual Rear Wheel)).
3. Install the brake pads to the brake caliper bracket. Place the new pads in the same orientation as noted during removal.
4. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
5. Lower the vehicle.
6. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
7. Slowly release the brake pedal.
8. Wait 15 seconds, then repeat steps 6-7 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
9. Fill the master cylinder reservoir to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling (See: Hydraulic
System/Brake Master Cylinder/Service and Repair/Procedures/Master Cylinder Reservoir Filling).
10. Burnish the brakes pads and rotors as necessary. Refer to Brake Pad and Rotor Burnishing (See: Brake Pad and Rotor Burnishing).
