Savana 4500 V8-6.6L DSL Turbo (2009)
11. Connect the rear master cylinder brake pipe fitting (1) and tighten to 25 Nm (18 lb ft).
12. Install the brake modulator shield, if equipped.
13. Install the brake modulator shield bolt and tighten to 25 Nm (18 lb ft).
14. Install the 2 brake modulator shield nuts and tighten to 25 Nm (18 lb ft).
15. If equipped with AWD, install the LF suspension torsion bar. Refer to Torsion Bar and Support Assembly Replacement (See: Steering and
Suspension/Suspension/Torsion Bar/Service and Repair).
16. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and Charging/Battery/Battery
Cable/Service and Repair).
17. Bleed the antilock brake system. Refer to Antilock Brake System Automated Bleed Procedure (See: Brake Bleeding/Service and Repair).
