Savana 4500 V8-6.6L DSL Turbo (2009)
Oil Level Sensor: Service and Repair
Engine Oil Level Sensor and/or Switch Replacement
Removal Procedure
1. Remove the lower oil pan. Refer to Lower Oil Pan Replacement (See: Oil Pan/Service and Repair/Lower Oil Pan Replacement).
2. Remove the oil level sensor clip (3).
3. Remove the oil level sensor bolt (2) and sensor (1).
Installation Procedure
Note: When routing the oil level sensor wire, ensure that the wire is routed along the side of the oil pan.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
1. Install the oil level sensor (1) and bolt (2) and tighten to 9 Nm (80 lb in).
2. Install the oil level sensor clip (3).