Savana 4500 V8-6.6L DSL Turbo (2009)
Note: Do not damage the sealing surfaces when separating the lower oil pan from the upper oil pan.
4. Separate the lower oil pan from the upper oil pan using the J 37228 .
5. Remove the lower oil pan.
6. If replacing the lower oil pan perform the following steps, otherwise proceed to step 4 in the installation procedure.
7. Remove the oil level sensor retaining clip (3).
8. Remove the oil level sensor bolt (2) and sensor (1).
Installation Procedure
1. If the lower oil pan was replaced perform the following steps, otherwise proceed to step 4.
Note: When routing the oil level sensor wire, ensure that the wire is routed along the side of the oil pan.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).