Savana 4500 V8-6.6L DSL Turbo (2009)
4. Install the center intake manifold lower 2 nuts (2) and 2 bolts. Tighten the nuts to 10 Nm (89 lb in).
5. Install the center intake manifold upper 4 bolts (1) and tighten to 10 Nm (89 lb in).
6. Connect the engine wiring harness electrical connector to the IAT sensor No. 2. Refer to Intake Air Temperature (IAT) Sensor 2 Replacement (
See: Powertrain Management/Computers and Control Systems/Intake Air Temperature Sensor/Service and Repair).
7. Position the connector bracket and install the bolt (2) and nut (1). Tighten the bolts to 15 Nm (11 lb ft).
8. Install the fuel rail clamp bolt (2) and tighten to 25 Nm (18 lb ft).
9. Install the connector bracket bolt (1) and tighten to 15 Nm (11 lb ft).
10. Install the turbocharger. Refer to Turbocharger Replacement (See: Powertrain Management/Fuel Delivery and Air
Induction/Turbocharger/Service and Repair/Removal and Replacement/Turbocharger Replacement).
