Savana 4500 V8-6.6L DSL Turbo (2009)
Installation Procedure
1. Apply clean engine oil to the NEW oil filter gasket.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the NEW oil filter and tighten after contact plus 1 to 11/4 turn.
3. Tighten the oil pan drain plug to 84 Nm (62 lb ft).
4. Remove the oil drain pan from under the vehicle.
5. Lower the vehicle.
6. Fill the engine with new engine oil. Refer to Approximate Fluid Capacities (See: Service Intervals) and Fluid and Lubricant Recommendations (
See: Service Intervals).
7. Start the engine.
8. Inspect for oil leaks after engine start up.
9. Turn off the engine and allow the oil a few minutes to drain back into the oil pan.
