Savana 4500 V8-6.6L DSL Turbo (2009)
6. Remove the power brake booster inlet hose (1) from the power brake booster (2).
7. Remove the power brake booster inlet hose from the vehicle.
Installation Procedure
Caution: Refer to Installing Hoses without Twists or Bends Caution (See: Service Precautions/Vehicle Damage Warnings/Installing Hoses
without Twists or Bends Caution).
1. Route the hose in the same position the hose occupied prior to removal.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the power brake booster inlet hose (1) to the power brake booster (2). Hand tighten.
3. Raise the vehicle.
4. Install the power brake booster inlet hose (2) to the power steering pump (1) through the wheel well. Tighten the hose fitting to 33 Nm (24 lb ft).
5. Lower the vehicle.
6. Tighten the power brake booster inlet hose to the power brake booster to 33 Nm (24 lb ft).
7. Bleed the power steering system. Refer to Power Steering System Bleeding (See: Steering and Suspension/Steering/Power Steering/Power
Steering Bleeding/Service and Repair).
8. Remove the drain pan from under the vehicle.
Power Brake Booster Outlet Hose Replacement
Power Brake Booster Outlet Hose Replacement
