Savana 4500 V8-6.6L DSL Turbo (2009)
1. Install the fuel level sensor, if necessary. Refer to Fuel Level Sensor Replacement (See: Computers and Control Systems/Fuel Level
Sensor/Service and Repair).
2. Install the sending unit and a NEW seal.
Note:
*
Always replace the fuel sender seal when installing the fuel sender assembly. Replace the lock ring if necessary. DO NOT apply any type of
lubrication in the seal groove.
*
Ensure the lock ring is installed with the correct side facing upward. A correctly installed lock ring will only turn in a clockwise direction.
3. Use the J 45722 in order to install the fuel sender lock ring. Turn the fuel sender lock ring in a clockwise direction.
4. Install the fuel tank. Refer to Fuel Tank Replacement (See: Fuel Tank/Service and Repair).
