Savana 4500 V8-6.6L DSL Turbo (2009)
Note: Do not remove the centering tab from the new SIR coil until the installation is complete. If the SIR coil does not come with a centering tab,
you must center the SIR coil.
2. If reusing the existing coil it MUST be centered, refer to Inflatable Restraint Steering Wheel Module Coil Centering (See: Procedures).
3. Align the SIR coil assembly (1) with the horn tower on the turn signal cancel cam assembly (2).
4. Slide the SIR coil (4) onto the steering shaft assembly (2).
5. Firmly seat the retaining ring (3) into the groove on the steering shaft assembly (2).
6. Remove and discard the centering tab from the new SIR coil (4).
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
7. Install the upper trim cover (1) and secure by using 2 TORX(R) head screws (2) and tighten to 1.5 Nm (13 lb in).
