Savana 4500 V8-6.6L DSL Turbo (2009)
Intake Air Temperature Sensor: Service and Repair
Intake Air Temperature (IAT) Sensor 2 Replacement
Intake Air Temperature (IAT) Sensor 2 Replacement
Removal Procedure
1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection (See: Starting and
Charging/Battery/Battery Cable/Service and Repair).
2. Remove the air intake pipe. Refer to Air Intake Pipe Replacement (See: Engine, Cooling and Exhaust/Engine/Tune-up and Engine Performance
Checks/Air Cleaner Housing/Air Cleaner Fresh Air Duct/Hose/Service and Repair/Air Intake Pipe Replacement).
3. Disconnect the intake air temperature (IAT) sensor (2) electrical connector.
4. Remove the IAT sensor from the center intake manifold.
Installation Procedure
