Savana 4500 V8-6.6L DSL Turbo (2009)
Important: Ensure that the tape tab is pointing away from the battery prior to installation.
1. Slide the NEW battery current sensor (1) up onto the negative battery cable.
2. Using NEW tie straps and electrical tape, attach the battery current sensor to the negative battery cable.
3. Install the negative battery cable. Refer to Battery Negative Cable Replacement (With LMM Primary) (See: Battery Cable/Negative/Service and
Repair)Battery Negative Cable Replacement (With LMM Auxiliary) (See: Battery Cable/Negative/Service and Repair)Battery Negative Cable
Replacement (With LY2, LMF or LY6) (See: Battery Cable/Negative/Service and Repair)Battery Negative Cable Replacement (With LU3 and
RVS) (See: Battery Cable/Negative/Service and Repair).
4. Connect the I/P harness electrical connector (1) to the battery current sensor.
