Savana 4500 V8-6.6L DSL Turbo (2009)
Installation Procedure
1. Install the intermediate shaft seal.
2. Connect the intermediate shaft bearing to the upper intermediate shaft.
3. Connect the intermediate shaft bearing to the studs on the cowl.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
4. Install the intermediate shaft bearing lower brace retaining nut and tighten to 30 Nm (22 lb ft).
5. Install the intermediate shaft bearing bracket retaining nuts and tighten to 30 Nm (22 lb ft).
6. Install the upper intermediate shaft to the intermediate shaft bearing retaining bolt and tighten to 30 Nm (22 lb ft).
7. Install the intermediate shaft seal upper retaining screws and tighten to 2 Nm (18 lb in).
8. Install the charged air cooler. Refer to Charged Air Cooler Replacement (See: Powertrain Management/Fuel Delivery and Air
Induction/Turbocharger/Intercooler/Service and Repair).
