Savana 4500 V8-6.6L DSL Turbo (2009)
1. Remove the inner shaft and housing assembly. Refer to Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement (See: Service and
Repair/Removal and Replacement/Front Drive Axle/Front Drive Axle Inner Shaft and Inner Shaft Housing Replacement).
2. Remove the inner shaft from the inner shaft housing.
3. Install the inner shaft housing into a vise.
4. Install the J 29369-1 (2) to the backside of the seal or bearing as necessary.
5. Install the J 2619-01 (1) to the J 29369-1 (2).
6. Remove the seal or the seal and bearing by pulling on the J 2619-01 .
Installation Procedure
1. If replacing the right side bearing, perform the following steps:
1. Install the inner shaft housing into a vise.
2. Install the bearing with the square shoulder in using the J 42211 (2) and the J 8092 (1).
