Sierra 1500 2WD V6-4.3L (2008)
6. Install and twist the cable housing to secure to the accelerator pedal assembly.
7. Install the accelerator pedal bracket mounting nuts.
Tighten the nuts to 9 N.m (80 lb in).
8. Adjust the accelerator pedal mounting bracket using the following procedure:
1. Remove the screws from the cable housing at the top of the adjustable pedal motor.
2. Twist the cable housing to unlock the cable from the motor.
3. Remove the cable from the adjustable pedal motor.
4. Attach a drill motor or equivalent to the adjustable pedal cable.
5. Spin the cable until there is a distance of 6.14 mm (0.24 in) between the arrows on the inboard side of the adjustable pedal bracket.
9. Install the accelerator pedal position sensor assembly.
10. Install the driver knee bolster.
11. Verify operation of the adjustable pedals.
