gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Brakes - Front Brake Induced Pulsation/Vibration|Page 21182 > < Brakes - Front Brake Induced Pulsation/Vibration
Page 2
background image

If the Front Pad Kit listed is used to correct any condition other than the condition described in this bulletin, the vehicle could experience higher mileage
corrosion-induced brake pulsation.

If the condition described HAS NOT been verified, or if the condition observed IS NOT most noticeable through the steering wheel, the observed
condition may have a different cause, such as a tire/wheel or rear brake issue, etc. Refer to SI for any further related diagnostics. 

If the condition described has been verified, and if the condition is most noticeable through the steering wheel, and if the condition was eliminated after
driving the vehicle on relatively flat ground, typically for 1.5-3‹›km (1-2 mi), perform the following inspections and repairs.

Important

-

It is critical to use the proper OEM brake rotors. Use of Non-OEM rotors may prevent the condition from being corrected long term.

-

If Non-OEM rotors are identified, these rotors are NOT covered under the GM New Vehicle Limited Warranty.

1. Inspect the front brake rotors to ensure that they are OEM rotors. 

-

Remove the brake rotor from the vehicle. 

-

Inspect the back side of the rotor for the Bosch Logo. If the Bosch logo IS NOT present, replace with OEM GM rotors, P/N 25819670.

2. Inspect the front brake rotors for Assembled Lateral Runout (LRO) and thickness variation. Follow SI procedures.
3. Inspect the front brake rotors for minimum thickness. Follow SI procedures.
4. If the rotors are within specifications, DO NOT refinish or replace the rotors.
5. If the rotors are out of specifications, refinish the rotors on a qualified lathe, or replace the rotors as appropriate. Follow SI procedures.

Note
To prevent a noise concern, follow the brake pad insulator preparation and seating instructions as referenced in Front Brake Pad Replacement
(1500) in SI.

6. Install the specified front pad kit, GM P/N 25910432. Follow SI procedures.
7. Ensure that the condition has been eliminated under the same conditions.

Parts Information

Warranty Information

Brakes - Front Brake Induced Pulsation/Vibration|Page 21182 > < Brakes - Front Brake Induced Pulsation/Vibration