Sierra 1500 2WD V6-4.3L (2008)
Arm Rest: All Technical Service Bulletins
Interior - Front Seat Armrest Bolt Accessory Cover
Bulletin No.: 07-08-50-014
Date: June 20, 2007
INFORMATION
Subject:
Front Center Seat Armrest Bolt Accessory Cover Available for Service Use
Models:
2007-2008 Chevrolet Avalanche, Silverado, Suburban, Tahoe
2007-2008 GMC Sierra, Yukon, Yukon XL
with Driver and Passenger Front Seat Split, Full Feature Center (RPO AZ3)
The front center seat armrest bolt accessory cover is now available for service as a separate part. The front center seat armrest bolt accessory cover was
formerly available as part of the entire front center seat assembly.
DO NOT replace the entire front center seat assembly. If the front center seat armrest bolt finish cover (1) is required, use the following steps below:
Open the passenger door.
Position the passenger front seat track all the way back.
Tilt the passenger seat back to the full tilt back position.
Remove the right front center seat armrest hinge cover plastic retainer with a door trim tool.
Use a screwdriver to release the inner tabs inside the right front center seat armrest hinge finish cover.
Remove the right front center seat armrest hinge finish cover.
Pull outward on the front portion of the center seat armrest bolt accessory cover to release the metal retaining clip.
Remove the front center seat armrest bolt accessory cover.
Remove the metal clip from the old center seat armrest bolt accessory cover.
Install the metal clip onto the new front center seat armrest bolt accessory cover.
Install the new front center seat armrest bolt accessory cover to the armrest assembly and firmly seat the metal clip.
Install the right front center seat armrest hinge finish cover.
Install the plastic retainer.
Tilt the passenger seat back to the up position.
