Sierra 1500 2WD V6-4.3L (2008)
product into HVAC modules and instrument panel ducts for the control of non-bacterial related odors.
Important: This product leaves no residual scent and should not be used as an air freshener.
This product may result in the permanent elimination of an odor and may be preferable to customers whose allergies make them sensitive to perfumes.
This product may effectively remove odors when directly contacting the odor source. In cases such as water leaks, use this product with diagnostic
procedures to first eliminate the primary cause of the odor. Then use further applications on the residual odor to permanently correct the vehicle
condition.
How to Use this Product
*
Spray GM Vehicle Care Odor Eliminator directly or as an additive with carpet shampoo in steam cleaners.
*
Do not use on any interior surface that plain water would deteriorate, because this product will have the same effect. Also avoid letting this product
come into contact with vinegar or any acidic substance. Acid-based products will hamper the effectiveness of GM Vehicle Care Odor Eliminator.
*
Complete eight page treatment sheets are enclosed within each case of GM Vehicle Care Odor Eliminator. These treatment instructions range from
simple vehicle odor elimination to full step by step procedures for odor removal from water leaks.
*
Instructions and cautions are printed on the bottle, but additional help is available. If you encounter a persistent or recurring odor, you may call to
obtain additional information and usage suggestions.
Floor Carpet Drying
Floor Carpet Drying
If the carpet or the pad or insulator is wet, use the following criteria for drying or for replacing the components:
*
For a 1-piece carpet assembly bonded to a cotton or a fiber padding, replace the entire assembly.
*
For a 2-piece carpet assembly with a cotton or a fiber padding, replace the padding only. While the carpet is out of the vehicle, dry the carpet using
the method described below.
*
For a 1-piece carpet assembly bonded to a foam padding or attached to a synthetic padding, dry the carpet using the method described below.
*
For a 2-piece carpet assembly with a synthetic padding, dry the assembly using the method described below.
Drying Method
1. If you observe puddles of liquid on the carpet face, use a wet vacuum to remove the excess moisture.
2. Blot the face of the carpet with a towel in order to absorb as much moisture as possible.
3. Point a fan at the affected area and air dry the carpet.
Front Floor Panel Carpet Replacement (Crew Cab)
Front Floor Panel Carpet Replacement (Crew Cab)
