Sierra 1500 2WD V6-4.3L (2008)
Sunroof / Moonroof Motor: Testing and Inspection
Sunroof Motor/Actuator Initialization/Teach Process (Crew Cab Existing Motor)
Sunroof Motor/Actuator Initialization/Teach Process (Crew Cab Existing Motor)
Re-Initialization/Teach Procedure (Manual Method), possible Re-Installation
Perform the initialization/teach procedure at the first operation test of the sunroof. Ensure the electrical harness on the headliner is connected to the large
roof, battery power is applied and the ignition switch is on.
1. Press the sunroof switch to the VENT OPEN position until the window reaches the vent open soft stop position and release. Press the sunroof
switch - vent open and hold for approximately 10 seconds, until the window stalls at the front hard stop in the vent open position, and then moves
slightly to the soft stop position. Release the button. (This is the re-initialization portion.)
Continue with steps 2-4.
2. Within 3 seconds, press and hold the sunroof switch-vent open again. The sunroof window will move toward and past the flush position. (This is
the teach portion.)
3. Continue holding the switch until the sunroof window moves to full open and then back to close and stops at the closed position. Release the
button. The initialization/teach procedure is complete.
4. Verify the operation of the roof.
The initialization/teach procedure is not completed if one of the following events occurs before the initialization/teach cycle is finished:
*
The sunroof switch is not held in the VENT OPEN position.
*
Ignition and/or battery power has been removed.
*
Glass panel has not reached the CLOSE position.
If the initialization/teach procedure is not carried out completely, it must be started again.
