gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

Campaign - Incorrect Speedometer Calibration|Page 23680 > < Campaign - Incorrect Speedometer Calibration|Page 23671
Page 1
background image

Speedometer Module: Recalls
Campaign - Incorrect Speedometer Calibration

Subject:
Service Update for Inventory and Customer Vehicles - Incorrect Speedometer Calibration - Expires with Base Warranty
# 07270 - (11/01/2007)

Models:
2008 GMC Sierra

Canadian and Export Vehicles

THIS SERVICE UPDATE INCLUDES VEHICLES IN DEALER INVENTORY AND CUSTOMER VEHICLES THAT RETURN TO THE
DEALERSHIP FOR ANY REASON, AND WILL EXPIRE AT THE END OF THE INVOLVED VEHICLE'S NEW VEHICLE LIMITED
WARRANTY PERIOD.

Purpose

This bulletin provides a service procedure to reprogram the instrument panel cluster. These vehicles may have an incorrect speedometer calibration. On
vehicles with this condition, the vehicle speed would be up to 7 kilometers per hour slower than what is shown on the speedometer.

Vehicles Involved

A list of involved vehicles currently in dealer inventory is attached to the Dealer Communication (Canada) used to release this bulletin. Customer
vehicles that return for service, for any reason, and are still covered under the vehicle's base warranty, and are within the VIN breakpoints shown, should
be checked for vehicle eligibility in the appropriate system listed below.

IMPORTANT:

Dealers are to confirm vehicle eligibility prior to beginning repairs by using the GM Vehicle Inquiry System (GMVIS). Not all vehicles within the
above breakpoints may be involved.

Parts Information

No parts are required for this program.

Service Procedure

IMPORTANT:

The Tech 2 diagnostic tool must be updated with version 27.011 or later for reprogramming the instrument panel cluster. Use TIS2Web
version 11 for 2007 (available on 10/31/07) or TIS DVD 11 (available on 11/09/07). If you cannot access the Tech 2 Update , call the
Techline Customer Support Centre and it will be provided.

1.

Verify the Tech 2 is installed with software version 27.011 or later.

2.

Connect the Tech 2 to the vehicle.

3.

With ignition ON and engine OFF, navigate to the IPC Recalibration procedure by either of the following two paths:

^

Diagnostics » 2008 » LD Trk, MPV, Incomplete » GMC Truck» C or K» Sierra » Body » Instrument Panel Cluster» Module Setup» IPC
Recalibration

^

OR

Campaign - Incorrect Speedometer Calibration|Page 23680 > < Campaign - Incorrect Speedometer Calibration|Page 23671