Sierra 1500 2WD V6-4.3L (2008)
Wheel Fastener: Service and Repair
Rear Suspension
Wheel Stud Replacement
Tools Required
J 43631 Ball Joint Remover
Removal Procedure
1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the tire and wheel. Refer to Tire and Wheel Removal and Installation (See: Service and Repair) .
3. Remove the brake rotor. Refer to Rear Brake Rotor Replacement (JD9) Rear Brake Rotor Replacement (JH6) Rear Brake Rotor Replacement
(JH7) .
4. Remove the wheel stud from the hub flange using the J 43631 .
5. Remove the wheel stud from the hub flange.
Installation Procedure
1. Install the new stud into the hub flange hole using firm hand pressure.
2. Install 4 washers to the new wheel stud.
3. Thread a wheel nut onto the new stud with the flat side facing the front hub flange .
4. Tighten the lug nut until the stud contacts the back of the hub flange.
5. Remove the wheel nut.
6. Remove the washers.