gmc Workshop Repair Guides

GMC Workshop Service and Repair Manuals

A/T - Fluid Leak From Bell Housing Area|Page 13717 > < A/T - Fluid Leak From Bell Housing Area|Page 13715
Page 11
background image

Important
DO NOT replace the transmission control valve body, transmission control module (TCM) or transmission fluid pump cover assembly.

1. Verify the customer's concern with the described conditions above. Then replace the 1-2-3-4 and 3-5-R clutch fluid seal rings.
2. Remove the transmission assembly from the vehicle. Refer to Transmission Replacement in SI.
3. Remove the transmission oil pan. Refer to Automatic Transmission Fluid, Fluid Pan and/or Filter Replacement in SI.

Notice
When removing the transmission control valve body, discard the O-ring seals and install new seals, GM P/N 24236927. Failure to install control
valve body O-ring seals may cause internal transmission leaks and transmission damage.

4. Remove the transmission control valve body. Refer to Control Valve Body Assembly/Removal in SI.
5. Remove the transmission bell housing / fluid pump. Refer to Torque Converter Housing with Fluid Pump Removal in SI.

Notice
The three clutch fluid seal rings are required to be installed in a specific way. Failure to install new clutch fluid seal rings may cause internal
transmission leaks and transmission damage. 

6. Inspect and remove the three clutch fluid seal rings (1). Install new pump rings, GM P/N 24238248. Refer to 1-2-3-4 and 3-5 Reverse Clutch Fluid

Seal Ring Installation (6L80/90) in SI for correct installation.

7. After completing the repair procedure, a Service Fast Learn Adapts procedure must be completed. Refer to Service Fast Learn Adapts in SI for

procedure details. After completing the Service Fast Learn Adapts procedure, the vehicle may still experience some minor driveability issues but
should learn improved shifting performance over the next several key cycles and driving time. Review with the customer the facts about the
transmission's ability to self-correct shifting issues or concerns. The transmission adapts are always functional and operate at transmission oil
temperatures about 40°C (104°F).

Parts Information

Warranty Information

For vehicles repaired under warranty, use the table.

Disclaimer

A/T - Fluid Leak From Bell Housing Area|Page 13717 > < A/T - Fluid Leak From Bell Housing Area|Page 13715