Sierra 1500 2WD V6-4.3L (2008)
Clutch Disc: Service and Repair
Clutch Assembly Replacement
Special Tools
J 5824-A Clutch Alignment Tool
Removal Procedure
1. Remove the transmission. Refer to Transmission Replacement (See: Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement/Tremec 5-Speed (TZ0) - Manual Transmission/Transmission Replacement) .
2. Remove the clutch pressure plate bolts.
Important: Dowel pins are used to align the flywheel and pressure plate. When removing the pressure plate check to see if the dowel pins
are rusted into the pressure plate, if so remove, clean, and reinstall the dowel pins into the correct location(s) on the flywheel.
3. Remove the clutch pressure plate and disc from the dowel pins.
Installation Procedure
1. If equipped with a 4.8L or 6.0L engine, install the clutch pressure plate and driven plate to the dowel pins.
2. Install J 5824-A in order to align the clutch.
3. Install the clutch pressure plate bolts finger tight.
Notice: Refer to Fastener Notice .
