Sierra 1500 2WD V6-4.3L (2008)
1. Place the new small seal clamp (2) onto the small end of the joint seal (1). Compress the joint seal (1) and small seal clamp (2) onto the halfshaft
bar.
2. Position the small end of the joint seal (1) into the joint seal groove (3) on the halfshaft bar.
Notice: Refer to Fastener Notice .
3. Secure the small seal clamp (1) with J 35910 , or equivalent, a breaker bar, and a torque wrench.
Tighten the small seal clamp (1) to 136 N.m (100 lb ft).
4. Inspect the gap dimension on the clamp ear. Continue tightening until the gap dimension is reached.
