Sierra 1500 2WD V6-4.3L (2008)
1. Using the J 23690 (1) and the J 8092 (2), install the axle shaft bearing.
2. Drive the axle shaft bearing into the housing until the tool bottoms against the tube.
3. Using the J 21128 , install the axle seal.
4. Drive the tool into the bore until the axle shaft seal is flush with the axle shaft tube.
5. Install the axle shaft. Refer to Rear Axle Shaft Replacement See: Axle Shaft Assembly/Axle Shaft/Service and Repair.
6. Install the tire and wheel assembly.
7. Remove the support and lower the vehicle.
