Sierra 1500 2WD V6-4.3L (2008)
1. Install the control lever insulator (5) to the floor.
2. Assemble the control lever boot retaining bezel (1) to the boot (4) and insert the 4 plastic retainers (3) .
3. Install the control lever boot retaining bezel (1), boot (4) and secure the 4 plastic retainers (3) to the floor.
4. Lift and push the lower edge of the control lever boot as necessary in order to install the 4 retaining screws (2).
Notice: Refer to Fastener Notice .
Tighten the screws to 1.6 N.m (14 lb in).
5. Install the transmission control lever. Refer to Transmission Control Lever Knob Replacement (See: Tremec 5-Speed (M96) - Manual
Transmission/Transmission Control Lever Knob Replacement) .
Transmission Control Lever Knob Replacement
Transmission Control Lever Knob Replacement
Removal Procedure
1. Remove the control lever boot from the control lever.
Important: DO NOT move the shift lever assembly adjustment nut if replacing the control lever.
2. Remove the control lever.
Installation Procedure
