Sierra 1500 2WD V6-4.3L VIN X (2004)
1. Install the brake caliper bracket (1).
2. Perform the following procedure before installing the brake caliper bracket mounting bolts.
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with denatured alcohol or equivalent and allow to dry.
3. Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
3. Notice:
Refer to Fastener Notice in Service Precautions.
Install the caliper bracket mounting bolts (2).
For vehicles equipped with JH5 brake systems, tighten the caliper bracket mounting bolts to 200 Nm (148 ft. lbs.).
For vehicles equipped with JH6/JH7 brake systems, tighten the caliper bracket mounting bolts to 300 Nm (221 ft. lbs.).
4. Install the anti-rattle clips to the brake caliper mounting bracket.
5. Install the brake pads to the brake caliper mounting bracket.
6. Slide the brake pads in until they contact the rotor.
7. Install the brake caliper.
8. Install the tire and wheel assembly.
9. Lower the vehicle.
10. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of it's travel distance.
11. Slowly release the brake pedal.
12. Wait 15 seconds, then repeat steps 10-11 until a firm pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
W/NYS
Brake Caliper Bracket Replacement - Rear (15 Series w/NYS)
Caution: Refer to Brake Dust Caution in Service Precautions.
Removal Procedure
