Sierra 1500 2WD V6-4.3L VIN X (2004)
30. Connect the following electrical connectors:
^
The TP sensor (1)
^
The IAC motor (2)
^
The control port injector module (3)
31. Install the engine wiring harness clip bolt (4).
^
Tighten the bolt to 9 Nm (80 inch lbs.).
32. Position the bracket and cables.
33. Install the accelerator control cable bracket with the cables attached, to the throttle body.
34. Install the accelerator control cable bracket nuts.
^
Tighten the nuts to 9 Nm (80 inch lbs.).
35. Connect the following electrical connectors:
^
The A/C compressor clutch (1), if equipped
^
The A/C pressure switch (4), if equipped
36. Install the engine wiring harness clip (3) to the accelerator control cable bracket.
