Sierra 1500 2WD V6-4.3L VIN X (2004)
6. Install the valve spring (3).
7. Install the valve spring cap (2) onto the valve spring (3), over the valve stem.
8. Use the J 5892-D in order to compress the valve spring.Hook the slotted end of J 5892-D under the washer on the valve rocker arm bolt.
Caution:
Compressed valve springs have high tension against the valve spring compressor. Valve springs that are not properly compressed by or released
from the valve spring compressor can be ejected from the valve spring compressor with intense force. Use care when compressing or releasing the
valve spring with the valve spring compressor and when removing or installing the valve stem keys. Failing to use care may cause personal injury.
9. Apply steady pressure on the valve spring cap until the valve keys are accessible.
10. Use the J 38606 if the clearance does not permit use of the J 5892-D.
Notice:
Completely engage the J 38606 jaws on the valve spring. The J 38606 may slip off and scratch the valve spring. Replace the valve spring if the
valve spring becomes scratch.
11. Install the valve stem O-ring seal.
12. Install the valve stem keys. Use grease in order to hold the valve stem keys in place.
