Sierra 1500 2WD V6-4.3L VIN X (2004)
7. Install the shim washer (1) onto the bottom of the distributor shaft.
8. Install the tang washer.
9. Install the round washer.
10. Install the driven gear according to the index marks.
11. Align the rotor segment as shown for a V6 engine (1).
12. Install the gear and align the white paint mark on the bottom stem of the distributor, with the pre-drilled indent hole in the bottom of the gear (3).
13. Check to see If the driven gear is installed incorrectly, the dimple will be approximately 180 degrees opposite the rotor segment when it is
installed in the distributor.
CAUTION: Refer to Safety Glasses Caution in Service Precautions.
