Sierra 1500 2WD V8-5.3L (2008)
Clutch Release Bearing: Service and Repair
Release Bearing Replacement
Removal Procedure
1. Remove the transmission. Refer to Transmission Replacement (See: Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement/Tremec 5-Speed (TZ0) - Manual Transmission/Transmission Replacement) .
2. Remove the clutch release bearing.
*
Rotate the bearing in either direction.
*
The compression spring load will push the release bearing off the end of the clutch actuator bearing.
Installation Procedure
Important: DO NOT use cleaners or chemicals to clean the quill and DO NOT grease the quill.
1. Using a clean dry cloth, clean the exposed area of the actuator cylinder quill.
2. Install the NEW clutch release bearing to the clutch actuator cylinder.
*
Firmly push the clutch release bearing into place.
*
The release bearing will snap over the retainer tab and will be self-retained to the actuator cylinder.
3. Install the transmission. Refer to Transmission Replacement (See: Manual Transmission/Transaxle/Service and Repair/Removal and
Replacement/Tremec 5-Speed (TZ0) - Manual Transmission/Transmission Replacement) .