Sierra 1500 2WD V8-5.3L Hybrid (2004)
7. Remove the lower bolts from the rear of the fender.
8. Disconnect the electrical connectors from the running lights, if equipped.
9. Remove the screws from the wheelwell.
10. Remove the bolts from the bottom of the fender.
11. With an assistant, pivot the fender from the bottom to approximately 90 degrees in order to remove the fender.
Installation Procedure
1. With an assistant, install the fender to the pickup box at a 90 degree angle and lower gently.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the bolts to the bottom of the fender.
Tighten the bolts to 25 N.m (18 lb ft).
3. Install the screws to the wheelwell area.
Tighten the screws to 2 N.m (18 lb in).
4. Connect the electrical connectors to the running lamps, if equipped.
