Sierra 1500 2WD V8-5.3L Hybrid (2004)
2. Perform the following procedure before installing the backing plate bolts (15 Series only).
1. Remove all traces of the original adhesive patch.
2. Clean the threads of the bolt with brake parts cleaner or the equivalent and allow to dry.
3. Apply Threadlocker GM P/N 12345493 (Canadian P/N 10953488) to the threads of the bolt.
3. Notice:
Refer to Fastener Notice in Service Precautions.
Install the backing plate bolts.
^
Tighten the backing plate bolts to 135 Nm (100 ft. lbs.).
4. Install the park brake shoe.
5. Install the axle shaft.
6. Adjust the park brake shoe. Refer to Park Brake Adjustment.
7. Install the rotor.
8. Install the park brake cable to the lever.
9. Perform the following procedure to install the cable to the backing plate:
1. Compress the spring by pushing towards the lever.
2. Route the cable through the slot in the backing plate.
3. Push the cable housing into the backing plate until the locking tabs snap into place.
10. Notice:
Refer to Fastener Notice in Service Precautions.
^
Tighten the nut to the intermediate cable at the equalizer.
^
Tighten the nut to 3.5 Nm (31 inch lbs.).
11. Install the tire and wheel assembly.
12. Remove the safety stands.
