Sierra 1500 2WD V8-5.3L Hybrid (2004)
5. Notice:
Refer to Fastener Notice in Service Precautions.
For 15 series vehicles, install the equalizer and the nut to the threaded end of the intermediate cable.
^
Tighten the nut to 3.5 Nm (31 inch lbs.).
6. For 25/35 series vehicles, enable the park brake cable automatic adjuster. Refer to Enabling the Park Brake Cable Automatic Adjuster.
7. Remove the safety stands and lower the vehicle.
8. Adjust the park brake system.
Park Brake Cable Mounting Bracket Replacement
Park Brake Cable Mounting Bracket Replacement
Removal Procedure
1. Release the parking brake.
2. Raise and support the vehicle. Refer Vehicle Lifting
3. Release the tension on the cables by loosening the nut at the equalizer.
4. Disconnect the rear cables from the equalizer.
5. Remove the rear cables from the mounting bracket by depressing the retaining tabs and pulling rearward.
6. Remove the cable support bracket nuts.
7. Remove the cable support bracket.
Installation Procedure
