Sierra 1500 2WD V8-5.3L Hybrid (2004)
1. Relieve the fuel system pressure. Refer to the Fuel Pressure Relief Procedure.
2. Disconnect the fuel feed and return pipes (1) at the fuel rail.
3. Disconnect the evaporative emission (EVAP) canister purge tube (3).
4. Cap the fuel rail and EVAP pipes.
5. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
6. Remove the fuel pipe bracket nut (2).
7. Remove the fuel pipe bracket from the bellhousing stud.
8. Remove the heated oxygen sensor (HO2S) sensor connector from the bracket.
9. Remove the fuel hose/pipe clip from the bracket on the automatic transmission.
10. If equipped with 4-wheel drive (4WD), remove the fuel hose/pipe clip from the bracket on the transfer case.
11. Remove the clip from the bracket on the frame.
12. Remove the transfer case harness from the clip bracket.
13. Remove the EVAP canister.
IMPORTANT: The area around the electro-hydraulic control unit (EHCU) MUST be free from loose dirt to prevent contamination of disassembled
anti-lock brake components (ABS) components.
