Sierra 1500 2WD V8-5.3L Hybrid (2004)
Steering Angle Sensor: Service and Repair
Rear Position Sensor Replacement
Removal Procedure
1. Notice:
Refer vehicle Lifting.
Raise the vehicle. Refer to Vehicle Lifting.
2. Remove the steering gear protection shield (1) retaining bolts (3).
3. Disconnect the electrical connector (1).
4. Notice:
When removing the rear position cover from the steering gear be careful not to damage to the rear position sensor.
Remove the rear wheel position sensor cover (4) from the steering gear by prying on the cover using the slot.
5. Remove the rear wheel position sensor retaining bolts (3).
6. Important:
Check the inner tie rod boot for wear or damage.
If the boots are damaged replace the steering gear actuator.
7. Important:
