Sierra 1500 2WD V8-5.3L Hybrid (2004)
damaged, the replace the steering knuckle.
3. Install the steering knuckle.
4. Notice:
Refer to Fastener Notice in Service Precautions.
Connect the lower ball joint to the steering knuckle and install the retaining nut.
^
Tighten the retaining nut to 100 Nm (74 ft. lbs.).
5. Connect the upper ball joint to the steering knuckle and install the retaining nut.
^
Tighten the retaining nut to 50 Nm (37 ft. lbs.).
6. Install the brake hose bracket retaining bolt to the knuckle.
^
Tighten the bolt to 9 Nm (80 inch lbs.).
7. Connect the outer tie rod to the steering knuckle. Refer to Rack and Pinion Outer Tie Rod End Replacement in Power Steering Systems or Tie Rod
Replacement in Steering Linkage (Non- Rack and Pinion).
8. Install the wheel hub and bearing. Refer to Wheel Hub, Bearing, and Seal Replacement (RWD) Wheel Hub, Bearing, and Seal Replacement
(4WD).
9. Install the tire and wheel.
10. Remove the safety stands.
11. Lower the vehicle.
