Sierra 1500 2WD V8-5.3L VIN B HO (2006)
Seals and Gaskets: Service and Repair
ZF S6-650 - Manual Transmission
Transmission Input Shaft Seal Replacement
Transmission Input Shaft Seal Replacement
^
Tools Required
-
J 23907 Slide Hammer
-
J 44748 Seal Remover
-
J 44731 Input Shaft Oil Seal Installer
Removal Procedure
1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Remove the rear propeller shaft.
3. Remove the transmission.
Important: The clutch actuator hose can remain connected to the clutch actuator. Disconnecting the hose from the clutch actuator will allow the
hydraulic fluid to drain from the hydraulic system.
4. Remove the clutch actuator cylinder bolts. Do not disconnect the hose from the actuator.
5. Remove the clutch actuator cylinder.
6. Remove the front oil seal using J 23907 (2) and J 44748 (1).
Installation Procedure
1. Position the NEW seal in the front case with the part number facing out.
2. Using J 44731 install the input shaft seal.
