Sierra 1500 2WD V8-5.3L VIN Z Flex Fuel (2006)
Starter Heat Shield: Service and Repair
STARTER SHIELD REPLACEMENT
REMOVAL PROCEDURE
1. Remove the starter motor.
2. If equipped with a 4.8L, 5.3L, or 6.0L engine, remove the starter heat shield.
3. If equipped with a 8.1L engine, remove the starter heat shield bolts, and nut.
4. Remove the starter heat shield.
INSTALLATION PROCEDURE
1. If equipped with a 8.1L engine, install the starter heat shield.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the starter heat shield bolts, and nut.
-
Tighten the bolts to 3 N.m (35 lb in).
-
Tighten the nut to 5 N.m (44 lb in).
3. If equipped with a 4.8L, 5.3L, or 6.0L engine, install the starter heat shield.
4. Install the starter motor.
