Sierra 1500 2WD V8-6.0L Hybrid (2010)
Rear Wheel Speed Sensor Ring Replacement
Special Tools
*
J-8092 - Driver Handle
*
J-21128 - Axle Pinion Oil Seal Installer
*
J-23690 - Bearing Installer
*
J-2619-01 - Slide Hammer
*
J-45857 - Tone Wheel and/or Bearing Remover
*
J-45860 - Tone Ring Installer
Removal Procedure
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (See: Maintenance/Vehicle Lifting/Service and Repair).
2. Remove the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair
).
3. Remove the rear wheel speed sensor.
4. Remove the rear axle housing cover. Refer to Rear Axle Housing Cover and Gasket Replacement (8.6, 9.5 Inch Axles) ()Rear Axle Housing
Cover and Gasket Replacement (10.5/11.5 Inch Axle) ().
5. Remove the axle shaft. Refer to Rear Axle Shaft Replacement (See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft
Assembly/Axle Shaft/Service and Repair).
6. Remove the axle shaft seal, the bearing and the wheel speed sensor ring from the axle housing using the J-2619-01 - Slide Hammer (1) and the
J-45857 - Tone Wheel and/or Bearing Remover (2).
Installation Procedure
