Sierra 1500 2WD V8-6.0L Hybrid (2010)
3. Install a lug nut to the stud with the flat side of the nut toward the washers.
4. Tighten the lug nut to draw the stud into the hub and rotor assembly.
5. Inspect the hub and rotor assembly to ensure the stud is seated completely.
6. Remove the lug nut and the washers.
3. Install the hub and rotor assembly to the vehicle. Refer to Rear Axle Hub, Bearing, Cup, and/or Seal Replacement (See: Transmission and
Drivetrain/Drive Axles, Bearings and Joints/Axle Bearing/Service and Repair/Rear Axle Hub, Bearing, Cup, and/or Seal Replacement).
4. With the engine OFF, gradually apply the brake pedal to 2/3 of its travel distance.
5. Slowly release the brake pedal.
6. Wait 15 seconds, then repeat steps 4-5 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
7. Fill the master cylinder reservoir, if necessary. Refer to Master Cylinder Reservoir Filling (Non-Hybrid) (See: Hydraulic System/Brake Master
Cylinder/Service and Repair/Removal and Replacement/Master Cylinder Reservoir Filling)Master Cylinder Reservoir Filling (Two-mode Hybrid)
(See: Hydraulic System/Brake Master Cylinder/Service and Repair/Removal and Replacement/Master Cylinder Reservoir Filling).
8. Install the tire and wheel assembly. Refer to Tire and Wheel Removal and Installation (See: Maintenance/Wheels and Tires/Service and Repair).
9. If the brake rotor was refinished or replaced, burnish the brake pads and rotors. Refer to Brake Pad and Rotor Burnishing (See: Brake
Pad/Service and Repair/Procedures).
